Wednesday, December 21, 2016

I Think We Need A New Awning

This is the way we had the awning set up. I put a board down under the upright in front and screwed the upright to it. That way it wasn't in the way like it would be when it is attached to the side of the motorhome. It made it easier to walk around but it also made it more hassle to close up. 
A few nights ago it was windy. The awning was out and flapping pretty good. About 5 o'clock in the morning the Old Lady said she was worried about the awning because it was making so much noise. We were out trying to get the awning closed when it ripped. When we bought The Guppy the awning had already been ripped by high winds on the end that attaches to the motorhome. The previous owner had used a couple of furring strips and screws to attach the awning to the side of the motorhome. We figured we would have to replace it at some time, just have been wondering what design on the awning to get. The Old Lady would like one with the logo of her alma mater. Question is which one, Michigan Tech or Virginia Tech?? The school colors for Virginia Tech would sorta match the accent strips on The Guppy. Anywho, we had sorta figured on replacing it sometime this winter and now we really need to do it if we want shade.


I'm making a cover for the windshield and doors. I had an old tarp with a couple of rips in it so it wasn't much use for covering stuff. I was able to cut pieces out of it to cover the windshield and the windows in the doors. I have it taped together temporarily but will need to sew the pieces together as the tape isn't holding very well. I used aluminum tape as I thought it would hold better than duct tape. Well it doesn't seem to stick to the tarp very well. I bought some strip magnets to hold it in place and is laying smoother than in this picture. The strip magnet came in a roll, so I laid it out for a day or so to straighten out, but it still wants to curl. I laid the magnets out on the trunk of the car during the afternoon and  overnight. But when I cut pieces from it, they at times still want to curl.


Another thing I've done is put a piece of sheetmetal under the door for the water heater to direct the water away from the compartment under it. The relief valve on the water heater weeps after the water gets hot in the water heater. I replaced the relief valve and it still weeps some water. I thought maybe the city water pressure at campgrounds was too high, so I got a pressure regulator that is supposed to keep the pressure at 40-50 psi. It still weeps. There is no way to adjust the temperature on the water heater, which if I could lower the temp (which gets real hot) that might stop the problem. In any case, I thought this would at least stop the water from running down the door for the storage compartment below the water heater. Yesterday I saw some guys working on the skirting for a trailer here in the RV park and I asked if they had any scrap pieces of sheetmetal that I could have. The guy cut off a piece and gave it to me. I then cut it to size with my utility knife and installed it. I took the screws out across the bottom of the water heater and slipped the sheetmetal up under it and replaced the screws to hold the sheetmetal in place. The piece was bent at one edge and it makes a trough for the water to run off to the side and away from the compartment door.

3 comments:

  1. Seriously, don't you miss the snow?
    the Ol'Buzzard

    ReplyDelete
  2. The water heater thermostat may be going bad if it is getting real hot.

    ReplyDelete

No Anonymous comments,it's not that hard to think of a nom de plume.